TBS Crossfire Manual



Attention
These Long Range Systems are capable of radio frequency transmissions and output power that may be
not allowed in your country.
Please always check your local RF legislation to set the frequency and output power according to
the regulation.
A general rule for RC aircrafts is that they must be controlled always under sight of view, check your RC
regulation to keep up to date with regulations.
Getting ready
Getting set up and ready to fly is a quick and simple task. In most cases plug&play when using TBS
equipment.
FAQ
If you got any question after reading this manual you should visit the TBS FAQ section
Note
This manual is written based on  Crossfire FW 4.00 . If some functions are not available for you, please
update your Crossfire to this (Beta) or a later version.
Updating
In order to update and configure your Crossfire, you need the TBS Agent X, which you can download from
the TBS shop.
To update your Crossfire, connect it by the USB-port of the transmitter and run the update by Agent X.
The receiver will then get the update while the next binding (details can be found in the receiver update
section)
For detailed instructions on how to use the Agent X, have a look at the Agent X manual.


 



7