Instructions / Assembly

Switch Housing
Mounting Plate
Fan Blade
Pre-Installed Blade
to Motor Screws
9
Fig. 12
Remove the large screws in the face of the
motor. Discard any rubber blocks attached to
these screws. The rubber blocks are installed at
the factory to stabilize the motor during ship-
ment.
Attach each blade to the motor face using the
two screws attached to the blade arm (see gure
12). Take care not to bend the blade arms during
installation. This will cause your fan to wobble
while running.
Step 9 Fan Blade Assembly Installation
Try mounting the blades on opposing sides of the
motor face, This will help keep the fan more
level during blade installation.
Fig. 13
Place switch housing mounting plate onto fan,
line up the 2 keyway holes and rotate mounting
plate; locking it into place.
Insert single screw and tighten.
Tighten other 2 keyway screws (see gure 13).