Installation guide

D6600 NetCom

Operation

D6600 NetCom System Guide

5. Select the IP address tab, then click the "Specify an IP address" radio

button.

6. Enter an IP address and subnet mask

for the network you will be setting

up, such as 202.96.168.1.

Note: If you have any questions regarding the assignment of the IP

address or subnet mask, see the network administrator!

All devices that will be on this network must have the correct subnet mask and

gateway entered.

7. Some files may have to be copied to the computer.

This may require Microsoft

Windows

operating

system disk for the appropriate version you are using.

8. After copying the files, the PC may have to be restarted. If so, connect the Host PC's NIC card to the

network (hub) and restart the PC.

9. After the reboot is completed, you should perform the following check to see if the previous procedures

were correctly entered.

Open a MS-DOS window by selecting Start 

Programs  MS DOS Prompt:

10. Once the DOS Window appears,

type the command winipcfg

[ENTER].

The IP Configuration window should appear:

Note: Make sure that the Network Adapter is selected in

the first window, not a PPP adapter. Verify the IP

address, subnet mask, and whatever other

information is listed. (This information should

match the IP and subnet mask you assigned to this

computer in the previous steps).