Installation guide

D6600 NetCom

Operation

D6600 NetCom System Guide

If you have chosen to program the D6600’s initial NetCom parameters via the direct null modem serial connection, then

continue on with the following steps. These steps are ONLY necessary if the host computer running the D6200 Software is

connected to the D6600’s COM4 port via a direct NULL modem serial cable!

11. In Microsoft

Windows

operating system, click on

the Start button and then go to Settings and Control

Panel.

12. Once the control panel is open, find

and double-click on the “System” icon

to launch the System control panel.

13. From the Device Manager tab, select Ports. Highlight

the COM port (usually COM1) used to connect the

D6200 Software to the D6600 COM4 port via a direct

connect NULL Cable.

14. Highlight the port icon and

then click on the

"Properties…" button.

15. Under the Port

Settings tab,

select 38400

bits per second

baud rate and

then click OK.

3.1.2 Windows 2000/XP/NT

If the host computer is running Windows 2000/XP/NT and is new to the network the following steps MUST be

performed:

Note: Even though the screen captures are specific to Windows 2000, they are similar for Windows XP and NT.

Click on Start  Settings  Control Panel.

2. Once the control panel is open, find and

double-click on the “Network and Dial-up

Connections” icon to launch the Network

and Dial-up Connections control panel.

3. Find and double-click on the “Local Area Connection”

icon.