User's Manual

3
2. Place the battery pack in the compart-
ment so its metal plates contact the metal
tabs inside the compartment.
3. Replace the cover.
Warning:
Dispose of old batteries promptly
and properly. Do not burn or bury them.
Caution:
When you replace the battery, use a
RadioShack replacement battery pack.
Note:
When the headphones stop operating
properly, replace or recharge the battery pack.
Connecting to an Audio Source
To connect the transmitter to your audio
source, connect one end of the supplied ste-
reo audio cable to the transmitter’s
R/AUDIO IN
(red plug) and
L/AUDIO IN
(white plug) jacks.
Then plug the other ends into the audio
source's audio output or headphone jacks.
1. To operate the
transmitter, press
POWER
. The
power indicator
turns amber.
2. Press
POWER
to
switch the trans-
mitter to standby.
The power indi-
cator turns
green.
Note:
When the transmitter is not in use,
set it to standby to avoid interference with
other wireless devices.
OPERATION
Listening Safely
To protect your hearing, follow these guide-
lines when you use headphones.
• Set the volume to the lowest setting
before you begin listening. After you
begin listening, adjust the volume to a
comfortable level.
• Do not listen at extremely high volume
levels. Extended high-volume listening
can lead to permanent hearing loss.
• Once you set the volume, do not increase
it. Over time, your ears adapt to the vol-
ume level, so a volume level that does
not cause discomfort might still damage
your hearing.
Using Your Headphones
You can use multiple sets of headphones with
each transmitter. We do not recommend using
multiple transmitters in the same area.
1. Set the headphones’ channel (
1
–
3
) to
the same channel as the transmitter.
2. Turn on the transmitter and the audio
source.
3. To turn on the headphones, slide
ON/OFF
to
ON
. The POWER indicator lights.
Note:
If the POWER indicator is blinking,
the battery level is low and you must
recharge it before use.
4. Put on the headphones and adjust
VOL-
UME
to the desired listening level.
Note:
If you connected the transmitter to
an audio source’s headphone jack, set
the audio source’s volume control to its
mid-position, then adjust the head-
phones’
VOLUME
to the desired level.
5. To turn off the headphones, slide
POWER
ON/OFF
to
OFF
.
Notes:
• To preserve battery life, be sure to turn off
the headphones when you are not using
them.
• If reception is poor even when the batter-
ies are fully charged and you are near the
L/R
AUDIO IN
AC
Jack
CH
Switch
33-1186.fm Page 3 Tuesday, October 31, 2000 4:48 PM