Cat. No. 40-5029 STEREO 900 MHz WIRELESS SPEAKER SYSTEM Your Radio Shack 900 MHz Wireless Stereo Speaker System use the 800 MHz band to deliver high-quality stereo sound to almost anywhere in or around your home. Your Speaker System's three delectable channels, PLL (Phase-Locked Loop) circuitry and built-in antenna give you precise tuning, so you can enjoy your favorite sounds without disturbing others while you exercise or work around your yard or house — up to 150 feet away from your stereo.
PREPARATION CHOOSING A LOCATION Many factors affect the range of your system. To achieve the best performance: . Position the transmitter as far as possible from other electronic devices such as TVs, receivers, or VCR. Radio interference from these devices could affect your system's performance. + Position the transmitter away from large metal objects, as these could block your transmitter’s signals. Try several locations for the transmitter. Select the location that provides the best performance.
. If your audio source has a headphone jack, insert the adapter’s stereo plug into the audio source’s HEADPHONE jack. » If your audio source has a headphone jack, insert the adapter’s stereo plug into the back of the supplied stereo adapter. Then insert th i the audio source’s HEADPHONE jack. P ert the adapter into C} MODE SWITCH For normal stereo use, set the STEREO/MONO switch at the rear of the transmitter to STEREO position . If you are using a monaural system, set the switch to MONO position.
6) Set each speaker's MODE switch to L (for the Left stereo speaker) and R (for the Right stereo speaker) and set the transmitter's STEREO/MONO switch to STEREO or MONO position. 7) Adjust each speaker's VOLUME Control and Tone Control Knobs to a comfortable listening level to meet your personal preference. Be sure to turn off the speakers and transmitter when you are not using them. TRANSMISSION AUTO ON/OFF The transmitter has a built-in automatic transmit ONION controller.
PROBLEMS SOLUTIONS No sound Be sure the speakers are turned on. Replace the speakers’ batteries. Be sure the AC adapter is plugged in and has power, Be sure all cables are securely connected. Be sure the audio source is tuned on and turned to an active channel. Be sure the source's volume control is turned up. Be sure the speakers and transmitter are set to the same channel. Adjust the speakers’ volume control. Distorted audio Be sure the speakers and transmitter are set to the . same channel.
~Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult your local Radio Shack store or an experienced radio/TV technician for help. *If you cannot eliminate the interference, the FCC requires that you stop using your intercom system. Changes or modifications not expressly approved by Radio Shack may cause interference and void the user's authority to operate the equipment. CARE Keep the station dry; if it gets wet, wipe it dry immediately.
