Operation Manual

Need help? Call 1-800-763-9232
37
• Do not position the Command Center
near metal objects (such as heating
ducts) that can absorb RF signals.
• Keep fresh batteries in the 7-in-One.
Weak batteries reduce the 7-in-One’s
range.
After you have set up the 7-in-One to control
your devices (see “Quick Setup” on Page 7
or “Setting Up the 7-in-One” on Page 14), fol-
low these steps to set up the Command Cen-
ter:
1. Choose a location about 8 feet in front
of the components you want to control.
The location should be near an easily
accessible standard AC outlet, with line-
of-sight access to your components.
2. Plug the Command Center’s power cord
into the AC outlet and raise its telescop-
ing antenna.
3. Position the Command Center so its
black IR lens is facing your components.
4. Be sure the remote is not pointing
toward your equipment, then test the
Command Center by pressing
POWER
.
You should be able to control compo-
nents from any room.
Using the IR Signal Extension Cord
You can use the supplied IR signal extension
cord to control a device that is within 4 feet of
the Command Center but out of its direct line
of sight.
15-1995.fm Page 37 Thursday, March 2, 2000 7:40 AM