Operation Manual

Need help? Call 1-800-763-9232
74
Problems changing chan-
nels.
If your original remote
required an
ENTER
key-
stroke when changing
channels, press the
ENTER
key on the 7-in-
One after you enter the
channel number.
The red light blinks when
you press a key but you
receive no response from
your device.
Press the appropriate
device key (
CD
,
CBL
,
VCR
,
TV
,
TUNER
,
AMP
,
SAT
,
PLUG ’N
POWER
) for the device
you are trying to operate.
Make sure you aim your 7-
in-One at your device and
that you are within 15 feet
of the device before using
your remote.
You can turn your audio
component on and off and
control its volume, but you
cannot change preset
channels.
Some audio components
might need both a Tuner/
Receiver code (see Page
60) and an Amplifier code
(see Page 39) to control all
features of your audio
component.
Your satellite receiver
does not respond to the
codes listed in the manual.
The codes listed in this
manual are set up to oper-
ate your satellite receiver
on the 1st or 2nd
addresses only. Make
sure the satellite receiver
you are setting up can be
operated with an infrared
remote.
The 7-in-One does not
operate Bang & Olufsen
audio equipment.
Some Bang & Olufsen and
other manufacturers’
equipment operate at fre-
quencies higher than 100
kHz. The 7-in-One will not
operate such devices.
Problem Solution
15-1995.fm Page 74 Thursday, March 2, 2000 7:40 AM