Operation Manual

Operation
31
4. Press ENT. The scanner
stores the frequency in the
selected channel.
5. To move another monitor
memory frequency to the next
channel, press PGM and
repeat Steps 2
–4.
SCANNING THE STORED
C
HANNELS
To set the scanner to continuously
scan through all channels with
stored frequencies, simply press
SCAN.
SCAN and ▲ appear, the
scanner begins to rapidly scan
until it finds an active frequency,
and a bar flashes beneath the
bank being scanned.
If the scanner finds an active
frequency, it stops and displays
that channel and frequency
number, then it automatically
begins scanning again when the
transmission on that frequency
ends.
Ô
TURNING CHANNEL-
S
TORAGE BANKS OFF
AND ON
Channel-storage banks (1–10) are
on when they have a bar
underneath them and off when no
bar appears underneath them. To
turn off a channel-storage bank,
press that bank’s number key
during scanning. The bar under
the bank’s number disappears.
Ô
Ô NOTE Ô
• To reverse the
scanning direction,
press ▲ or ▼.
• To set the scanner
to remain on the
current channel for
2 seconds after
the transmission
ends, see “Delay”
on Page 41.
• To set the scanner
to remain on the
current channel,
even after the
transmission
stops, press
MAN
at any time during
the transmission
so
MAN appears
and
SCAN
disappears (see
“Monitoring a
Stored Channel”
on Page 32).
• To lock out
channels so the
scanner does not
stop for a
transmission on
those channels,
see “Locking Out
Channels or
Frequencies” on
Page 42.
Turning Channel
Storage Banks Off
and On
The scanner does not
scan any of the channels
within the banks you
have turned off.