User Manual

6
achieve optimum reception. You can adjust the appropriate volume
by rotating the [VOLUME] button.
Auto Tuning Storage (ATS) (Refer to 9 ）
FM ATS:
1. Fully extend the telescopic antenna and press the[BAND],
button to select FM band;
2. Press & hold the [BAND] button, The radio will automatically
search FM radio stations and store all available stations into
the memories;
3. When the frequency count stops, it means the ATS operation is
done completely. You can rotate the [TUNING] knob to search for
those stored stations.
Notes: The ATS operation in the MW, LW, SW and AIR bands are
basically the same as above; During ATS process in FM, MW / LW
or SW /AIR, pre-stored radio stations will be replaced automatically
by the new found stations.
STORING STATON MANUALLY (Refer to 9)
1. Select band and tune to your desired station;
2. Press the [MEMORY] button,“PRESET ” will start flashing;
3.Rotate the [TUNING] button to select the storage location（1-
100 ）;
4. Press the [MEMORY] button again to store the station into
memory.
LISTENING TO STORED STATIONS (Refer to 11)
1. Select your desired band by pressing [BAND] button;
2. Press the [VM/VF] button to switch into frequency mode, switch
to address status, with memory address number flashing;
3. Rotate the [TUNING] knob to tune into the stored station one
by one.