The World’s Leading Radon Fan Manufaturer RP Series Installation Instructions RadonAway 3 Saber Way Ward Hill, MA 01835 www.radonaway.
RadonAway Ward Hill, MA. Series Fan Installation Instructions Please Read and Save These Instructions. DO NOT CONNECT POWER SUPPLY UNTIL FAN IS COMPLETELY INSTALLED. MAKE SURE ELECTRICAL SERVICE TO FAN IS LOCKED IN "OFF" POSITION. DISCONNECT POWER BEFORE SERVICING FAN. 1. 2. 3. 4. 5. 6. 7. 8. WARNING! Do not use fan in hazardous environments where fan electrical system could provide ignition to combustible or flammable materials. WARNING! Do not use fan to pump explosive or corrosive gases.
INSTALLATION INSTRUCTIONS IN020 Rev K RP Series RP140 p/n 23029-1 RP145 p/n 23030-1 RP260 p/n 23032-1 RP265 p/n 23033-1 RP380 p/n 28208 1.0 SYSTEM DESIGN CONSIDERATIONS 1.1 INTRODUCTION The RP Series Radon Fans are intended for use by trained, professional Radon mitigators. The purpose of this instruction is to provide additional guidance for the most effective use of an RP Series Fan.
1.6 CONDENSATION & DRAINAGE Condensation is formed in the piping of a mitigation system when the air in the piping is chilled below its dew point. This can occur at points where the system piping goes through unheated space such as an attic, garage or outside. The system design must provide a means for water to drain back to a slab hole to remove the condensation. The RP Series Fan MUST be mounted vertically plumb and level, with the outlet pointing up for proper drainage through the fan.
1.8 ELECTRICAL WIRING The RP Series Fans operate on standard 120V 60 Hz. AC. All wiring must be performed in accordance with the National Fire Protection Association’s (NFPA)”National Electrical Code, Standard #70”-current edition for all commercial and industrial work, and state and local building codes. All wiring must be performed by a qualified and licensed electrician. Outdoor installations require the use of a U.L. listed watertight conduit.
2.1 MOUNTING Mount the RP Series Fan vertically with outlet up. Insure the unit is plumb and level. When mounting directly on the system piping assure that the fan does not contact any building surface to avoid vibration noise. Typical Indoor Installation 2.2 MOUNTING BRACKET (optional) The RP Series Fan may be optionally secured with the RadonAway P/N 25007-2 (25033 for RP385) mounting bracket. Foam or rubber grommets may also be used between the bracket and mounting surface for vibration isolation. 2.
RP SERIES PRODUCT SPECIFICATIONS The following chart shows fan performance for the RP Series Fan: Typical CFM Vs Static Pressure "WC 0" .25" .5" .75" 1.0" 1.25" 1.5" 1.75" 2.0" RP140 135 103 70 14 RP145 166 146 126 104 82 61 41 21 3 RP260 272 220 176 138 103 57 13 RP265 334 291 247 210 176 142 116 87 52 RP380* 130 80 38 497 401 353 281 220 176 * Tested with 6” inlet and discharge pipe. Power Consumption Maximum Recommended 120 VAC, 60Hz 1.
IMPORTANT INSTRUCTIONS TO INSTALLER Inspect the GP/XP/XR/RP Series Fan for shipping damage within 15 days of receipt. Notify RadonAway of any damages immediately. Radonaway is not responsible for damages incurred during shipping. However, for your benefit, Radonaway does insure shipments. There are no user serviceable parts inside the fan. Do not attempt to open. Return unit to factory for service.
