Operation Manual

1 Thermostat settings (for the main zone only)

On this submenu you can adjust the actual settings temperature and

humidity level for the main zone (zone managed by the programmer).

With the keys (◄-) or (►+) move the selection cursor in front of the

setting which must be adjusted, then press the (OK) key to start

blinking the value. Now you can adjust the value with (◄-) or (►+).

Once the value adjusted press (OK) to valid your adjustments.

- The day and night settings, will be these of the current working

mode (Heating or Cooling).

- The Humidity level is used only in cooling mode to prevent the

house of residual humidity in the air.

If humidity is detected the system will stop the cooling function in the

house and start up the humidity drier.

You could see the activation of this function in the status line of the

main screen.

Note:

You can reach quickly this menu by pressing the (OK) key during 2

seconds on the main screen.

Monday 27 / 04 / 2009

11 :15

22.6°C

33%

Thermostat Setti

 20.0°C

18.0°C

rH 60%

* The drop and the

level will be blink to

indicate the

humidity level is

reached in the

main room only.

** The drop will be

blink alone only

when humidity is

detected by the

UFH RF MASTER.