Operation Manual

32
To change the installation, move the navigation cursor in front of the
desired line and Press (Ok) to valid “”.
!!! Important note !!!
These modifications are only available if the Heating / Cooling
information has done by the main zone programmer. Check the
position of the “HC” parameter on the MASTER-RF of the installation.
(Check the leaflet of the MASTER-RF for more explanation)
Heating:
- To be use when your house is only equipped with heating system
only.
Cooling:
- To be use when your house is only equipped with cooling system
only.
Reversible => Heating & Cooling:
To be use when your house is only equipped with heating and
cooling systems.
- Two possibilities:
Manual change
The working mode heating or cooling will be done by the end user on
the special menu on the programmer, in the main menu. See the
next part “Heat & Cool Mode” for more information.
Automatic change (contact - sensor)
Generally use when automatic reversible heat pumps is installed.
The working mode heating or cooling will be done by the “MASTER-
RF”.
In this case the Heating or cooling information will be done by an
external sensor or a contact connected on a special input on the
MASTER-RF)
Installation type
 Heating 
Cooling
Reversible