Operation Manual

33
4.3.7 RF Installation
Use this submenu to install the main zone programmer with the rest
of the installation MASTER(s) and THERMOSTAT(s),
Routing rules to install a complete RF pack.
First of all you must install and connect all components, MASTER-
RF, ACTUATORS THERMOSTATS...
a) On the MASTER-RF, and enter in the parameters menu by
pressing 10 seconds on the (Ok) key, now search the “rF init”
parameter with (►) key, then press again on the (OK) key to
enter in the “rf init” mode.
The following message MASTER-RF display must be appear:
- The number in front of the “init” text corresponds to the
selected zone. (The corresponding LED on the MASTER RF
must be blink in green)
- Use (◄) & (►) keys to change the zone (01 to xx), the green
LED blinking cursor move in a same way of the zone number.
- With (OK) key you can select or de-select the zone(s) which
must be learned with a thermostat. The corresponding LED of
the selected zone(s) must be shine in red to indicate that this
zone(s) is in wait of thermostat signal.
b) When you have correctly selected the zones which must be
assigned with a RF thermostat go to the thermostat and
activate the “rF init” mode. (See the corresponding leaflet of the
RF thermostat to do this).
Installation
Pump exercise 
Units AM/PM...
Installation type
 RF installation