User manual

- 20 -
4. CAUTION: the front glass cannot be dismounted.
5. Remove the weighing pan, the pan shield and the bottom shield of the weighing
chamber so as not to damage the mechanism while carrying out the cleaning
process.
Thus prepared draft shield and its glass parts may be thoroughly cleaned. Carry
out the cleaning process carefully using the most gentle movements. Pay attention
to dirt and any small items, they could affect balance operation if they got inside
the balance through the opening that serves to mount the weighing pan.
Upon completion of the cleaning process assembly the balance, take actions like
before but in a reverse order. Pay a special attention to left and right side glass,
assembly it on the correct side of the balance. While sliding the glass back onto its
place remember to pull the protection (like before when dismantling the draft
shield).
2.7. Plugging to mains
The balance should be plugged to mains using the original power adapter,
which is balance’s standard equipment. Plug the power adapter’s plug to
balance’s socket located at the back of the housing.
2.8. Connecting peripheral equipment
Use only accessories and peripheral equipment recommended by the
manufacturer of your balance. The balance must be disconnected from the
mains before connecting or disconnecting any peripherals (printer, PC
computer, computer keyboard). On connecting the peripherals, plug the
balance to mains.