User manual
- 9 -
• Remove the weighing pan from balance’s housing and remove the
transport protections, as shown on above figure.
• After unpacking, unscrew bolt (1) locking balance’s adjustment
mechanism.
• Assembly the weighing pan.
• Pay attention to correct positioning of the weighing pan on balance’s
mandrels – the weighing pan must not touch balance’s housing, and it
should rest steadily.
• After removing transport protections, and assembling the weighing pan
connect the terminal to balance’s socket located at the back of the housing
– only non legalization balaces, and next connect needed peripheral
equipment. Only then plug the balance to mains (power socket is located
at the back of balance’s housing).
• Place the balance in its intended place of use.