User manual

- 40 -

Display refreshment
This function determines the amount of instantaneous measuring
data to be displayed during a weighing cycle. The balance enables
previewing all of instantaneous measuring data, i.e. then multiple
transient states are previewed.
Another extreme setting is previewing the lowest number of instantaneous
measuring data. In such case, approximately three transient states are previewed
on the display before reaching a stable measurement status.
 Autozero
Each measuring cycle starts from a so called “ZERO” point that is
indicated by pictogram on balance’s display. In practice, the
“ZERO” point is a area of approximate size of 0,25e.
Some processes, like filling, dosing, evaporating require disabling the autozero
system, for preventing from a measurement error. It is caused by the essentially
laminar character of the process.
In majority of the balances, the AUTOZERO system is enabled. In order to disable
to function set its parameter to NO. When entering the weighing mode with
disabled autozero function, the display does not indicate precise zero pictogram.
 Last digit
This functions has two settings: last digit: YES, or last digit: NO. If set
to YES, the balance displays all digits of a measuring result. If set to
NO, the last digit of a measuring result is blanked, and the
measurement is carried out with decreased accuracy.
18.4.4. Operation of buttons
This menu describes BALANCE REACTIONS to operation of the buttons. The settings
refer to:

Left proximity sensor
Select one of available processes to be carried out by the proximity sensor,
including:
o disabled
o printout
o tare
o open door /option available in a balance MYA.3Y series/
o close door /option available in a balance MYA.3Y series/
o change door /option available in a balance MYA.3Y series/
o units