User manual

- 59 -
Give standard quantity for standard procedure
Select standard quantity from a displayed message box or enter other value.
The order for carrying out the processes is indicated on the display by
corresponding messages.
A user can select among the
following options:
− Optional
− 10 parts
− 20 parts
− 50 parts
− 100 parts
Caution:
When setting a standard quantity
maintain the following condition: mass of
1 part > balance reading interval.
After selecting one of available options the COMMAND BAR displays an
appropriate information.
Enable or Save standard
Pressing this hot-key causes displaying DATABASE of STANDARDS for
carrying out the following two processes:
− Save mass of a standard /1 part/
in the database of standards
− Acquire mass of a standard
stored in the database of
standards
SAVING A STANDARD IN THE
DATABASE
o In the parts counting mode press
quick access key to enter
DATABASE OF STANDARDS
o Press “ADD” pictogram