User manual

- 63 -
18.8.4. Parameters of parts counting mode – information
Information items related to weighing are
displayed in the grey coloured workspace area.
The workspace enables containing up to 6
pieces of information.
If more than six parameters are enabled, then
only first 6 are displayed.
Bargraph YES
A bargraph refers to operation of the filling and checkweighing modes in the
parts counting mode.. The bargraph is a graphic interpretation of modes
operation. The bargraph is visible only if the hot-key “Checkweighing” or
“Filling” are enabled (set to YES) (set in menu for declaring presence of quick
access keys)
Supplementary unit YES
This field contains measuring result expressed in an additionally determined
measuring unit (supplementary unit) set in menu <Units>.
Tare YES
This field displays currently set tare value (displayed in currently set basic
measuring unit).
Gross YES
This field displays current gross value (displayed in currently set basic
measuring unit).
Counter YES
This field enables displaying data on number (sequence) of carried out
measurements
Low threshold NO
The information indicating the value of low threshold that is declared for
checkweighing mode, e.g. 20 pcs
High threshold NO
The information indicating the value of high threshold that is declared for
checkweighing mode. 25 pcs
Target value NO
The information indicating number of parts to be added to counted parts to
reach a target a in a filling process (in this case a filled quantity)
Statistics NO
Displaying of the statistics component can be attributed as: Yes or No.
ID codes NO
“ID1“,“ID2“, “ID3“, “ID4“, “ID5“: Field enables determining identifiers set using
a quick access key “ID“.
Note: When selecting an ID value “ID1“, “ID2“, “ID3“ and “ID4“ the balance displays
names (texts) corresponding to each determined ID.