Manual

• In the overlap <Transmission settings>:
− Set the communication mode as „RS232 transmission”,
− Select an appropriate com number,
− Configure the selected port (baud rate, parity, data bits, stop bits),
• Confirm the changes by clicking ,
• Rerun the program,
• Press the „Connect” button,
• The appropriate communication with scales is signalled by pictogram
in the left part of the display,
• Transmission problems are signalled by the message window:
32.2.3. Setting Ethernet parameters
On order to establish the connection with EDYTOR WPW through
Ethernet interface follow the remarks below:
• Power up the scale and run the EDYTOR WPW program,
• Connect the scale to a computer/switch using a PT0017 or PT0014
cable (depending on the Ethernet module on board – see ch. 27.1.2),
• Set the port for communication with a computer – parameter
<P3.1.1 COMP. PORT> set to Ethernet (see ch. 15.1.1),
- 164 -