User manual

13. RS 232 PARAMETERS
External devices connected to RS 232C have to be supplied from the
same mains and common electric shock protection. It prevents from
appearing a potential difference between zero leads of the two devices.
This notice does not apply to the devices that do not use zero leads.
Transmission parameters:
• Baud rate - 2400 ÷ 38400 bit / s
• Data bits - 7,8
• Stop bits - 1,2
• Parity control - no, even, odd
There are four ways of sending data via RS232 interface:
• Manual – after pressing
key,
• Automatic – after stabilizing the indication above -LO- threshold
• Continuous – after it is enabled in parameter or by a command sent
via RS232
• On external request - see – “Communication protocol – commands
sent from a computer”.
The indication can be sent as:
• stable – the indication is sent after the balance indication is stabilized.
• any – the indication is sent immediately after pressing the
key,
this state is marked with <?> indication in the printout.
13.1. Printout type
This parameter enables selecting type of printout.
Procedure:
• Enter the submenu <P2.Prnt> and then:
- 20 -