User manual

• Install the pan and the pillar (WTC/SW scales) according to below
drawing:
Assembly of scales WTC/S series Assembly of scales WTC/SW series
Caution:
1. During assembly of the pillar in the WTC/SW scale put attention not to
“cut” display tape.
2. Before starting the weighing remove (tear off) foil protecting scale pan.
6. STARTING AND OPERATION
• After assembly (see point 5 of manual) place the scale on flat and
hard surface far from heat sources.
• Scale should be levelled by turning regulation feet. Levelling is correct
if air bubble is in central position of level indicator placed in upper
(left) part of scale casing:
- 6 -