User manual

- 12 -
In case of analytical balance XA/2X series self-heating period takes approximately 1 hour.
The specified time interval refers to balances that have been stored in room temperature
before plugging to mains.
For balances that were stored in much lower temperatures before plugging to mains (e.g.
during winter period) thermal stabilization should last approximately 8 hours. During
temperature stabilization time the indications on balance’s display may change.
4. APPLICATION
Balance featuring a graphic display is intended to precise determining mass in laboratory
conditions. The balance enables zeroing the indication in whole measuring range.
Balance XA/2X series enables determining mass in the following measuring units:
Fig. 2. Measuring units
Apart from determining mass of weighed object using different measuring units, the
software balance XA/2X series comprises the following working modes:
Parts counting
Checkweighing
Dosing
Percent setup
Animal weighing
Determining density of solids, liquids and air
Mixtures from accepted formulation and ingredients
Statistics from completed measuring series
Formulation
Pipette calibration
Both measuring units and working modes can be set as inaccessible in the user menu.
This option is implemented for the purpose of adjusting balance to user needs and
requirements, i.e. providing access only to those functions and units which are required by
a user.
Determining accessibility attribute of a working mode / measuring unit is set in
balance’s menu and it is described further in this user manual.