User manual

- 7 -
2. UNPACKING AND INSTALLATION
2.1. Balance XA/2X series
Cut protective tape. Carefully remove the balance from its packaging. Remove from
the box all necessary accessories needed for correct operation of the balance. Gently
place the balance in its intended place of use. Install the weighing pan, and other
elements according to below scheme. The balance is powered from mains through a
power adapter: 110-230 V AC / 13,5-16V DC.
Analytical balance with weighing pan Φ 100 mm:
− open side sliding glass doors of the
weighing chamber,
− place the bottom shield (3) inside the
weighing chamber,
− next assembly the anti-draft shield (2)
of the weighing pan,
− finally, assembly the weighing pan (1)
inside the center of the anti-draft
shield,
− close side sliding glass doors of the
weighing chamber,
− plug the power adapter to mains, and
plug the adapter’s pin to balance’s
socket located at the back of the
housing.