Installation Guide

FinMInstallationGuide Release4.5.25 2‐8
TBSMounting SiteInstallation
Verticalpole‐medium
1. Diameter2to3:BeforeraisingtheTBSonthepole,positionthepoleclampasshownin
thefollowingtwofigures.Donotcompletelytightenthebolts:
2. PlacethisassemblyonthepolewhereyouwanttomounttheTBS.Onceitisinplace,
rotatethepoleclampasshown,thentightenbothbolts.
VerticalPole‐thick
1. Diameterlargerthan3:Usewormdriveclamps(notsupplied),threadedthroughtheholes
asshowninFigure 2‐15,orU‐bolts(notsupplied),fastenedusingtheholesasshownin
Figure 2‐16:
Figure2‐11:Mediumpole:Fastenclampto
baseplate
Figure2‐12:Mediumpole:Donotcom‐
pletelytightenbolts
Figure2‐13:Mediumpole:R otateclamp Figure2‐14:Mediumpole:tightenbolts