User's Manual Part 1

Quick Start Guide Installation and Operation Manual
Beeper Sequence
=beeper on
=beeper off
Description
[approx. 1s]
Best Signal so far
Signal quality increased
No change in signal
Signal quality decreased
[approx. 2s] No air link
Note
Three beeps and a pause is the best signal
Two beeps and a pause, signal quality increased
One beep and pause is no signal change
Any other signal detects no signal between ODUs.
8. Secure the site B ODU to the mast/wall.
9. At site A, adjust the ODU slowly while listening to the beeper
sequence until the best signal is attained.
10. Secure the site A ODU to the mast/wall.
11. Monitor the link quality for about 15 minutes to verify stability.
12. Connect the management station to one of the two IDUs in the link.
13. Double-click the WinLink 1000 Manager icon to start the
application.
14. Click the Installation button to open the installation wizard and
follow the installation steps.
After selection of the radio channel and the link rate (as determined in
the Link Budget Calculator utility), verify that the link quality bar in the
WinLink 1000 manager is within the green range for TDM service and
within the yellow range for Ethernet service.
6 Installing the WinLink 1000 Units WinLink 1000