User's Manual Part 1

Chapter 4
Configuration
This chapter describes configuration procedures, which are performed
after the physical installation of the local and remote WinLink 1000
units and the Installation Link wizard has been performed. A second
wizard is used to redefine the configuration parameters if necessary.
Both sites in the link are defined simultaneously.
The following parameters are configured via the Configuration Wizard:
• System parameters
• Frequency channel
• Air interface rate
• Service parameters
• TDM
• Hub Site Synchronization Settings.
The following parameters are configured via the Configuration dialog
box.
• Transmit power
• Management and trap addresses
• Bridge mode
• Ethernet mode
• Community values.
Note
For HSS screens specific to WinLink 1000-ACCESS-CL units see
Appendix F .
4.1 Configuring the System Parameters
After installing the link, the system configuration can be modified.
Note
All parameter changes are automatically applied to both sides of the
link.
Configuring the System Parameters 4-1