User's Manual Part 1

WinLink 1000 Installation and Operation Manual Chapter 4 Configuration
Figure 4-5. BRS Channel Settings Post-Transition
4.3 Configuring Service Parameters
The user defines the type of service required, Ethernet Only or Ethernet
with TDM. The bandwidth remaining available for Ethernet if TDM
services are required is shown in the dialog box.
WinLink 1000-ACCESS versions are Ethernet Only.
In the Service Parameters dialog box select if WinLink 1000 is to
provide E1/T1,
(x1 or x2 for IDU-E, or x4 for IDU-C). Define the required transmission
rate, and the distance between the sites.
Note
Æ
To configure E1/T1 and Ethernet services:
1. In the Service dialog box, select one of the following:
 Ethernet plus a number of E1/T1 channels (see
Figure 4-6 ).
Configuring Service Parameters 4-9