User's Manual

WinLink User and Installation Guide Version 1.795 3-35
2. Enter the default link password wireless-bridge.
3. Enter a new password.
4. Retype the new password in the confirm field.
5. Click OK.
6. Click Yes when asked if you want to change the link password.
7. Click OK at the successful message.
Note:
Restoring Factory Defaults returns the Link Password to wireless-bridge.
Re
Connecting the User Equipment
The IDU is a standalone desktop, wall-mounted, or rack-installed unit.
The following figure illustrates a typical front panel of the IDU:
Figure 3-12: Typical Front Panel of IDU-C
Æ To connect user equipment to the IDU:
1. Connect user E1/T1 traffic to the IDU panel RJ-45 port designated
TRUNK. There may be multiple Trunk ports available depending
on unit ordered.
Refer to
Wiring Specifications, for the connector pinout.
2. Connect user hub/router or any other compatible device to the IDU
panel RJ-45 port designated LAN. There may be multiple LAN ports
available for connecting to different LANs depending on the IDU
unit ordered.
Refer to
Wiring Specifications for the connector pinout.
Note:
Use a straight cable for router connection.
Do not connect two LAN ports to the same LAN, or flooding may occur.