User's Manual

Chapter 5 Diagnostics and Troubleshooting WinLink1000 Installation and Operation Manual
5.5 Testing WinLink1000
WinLink1000 supports activation of the internal and external loopbacks
on the local and remote units.
Æ
To activate a loopback:
1. From the Maintenance menu, choose Set Loopbacks.
The Loopbacks dialog box appears (see
Figure 5-7 ).
2. From the Local or Remote drop-down box, select a loopback that
you intend to run, and click OK.
A confirmation message appears.
3. Click OK to activate a loopback.
WinLink1000 activates selected loopback. A loopback status
arrow in the Main menu turns green to indicate an active
loopback.
Æ
To deactivate a loopback:
• From the From the Local or Remote drop-down box of the
Loopbacks dialog box, select None and click OK.
A loopback is deactivated and the corresponding status arrow in
the Main menu becomes dimmed.
Figure 5-7. Loopbacks Dialog Box
5-14 Testing WinLink1000