User's Manual

Chapter 2 Installation and Setup WinLink1000 Installation and Operation Manual
 Enter IP address (of the ODU)
Default address: 10.0.0.120
The Subnet mask is 255.0.0.0
.
•
Note
The actual IP address i defined during link configuration (see s Defining
the Management Addresses
).
4. Enter the password
Default password –
admin (see the section on Changing the
Management Password
)
5. Click the Read only check box if entering the system as a Read only
user.
6. If you are a user with Read-Write permission, click Options to enter
the community options.
WinLink1000 is protected with Community passwords. A user may
be defined with read-only permission or with read-write
permission. See the section
Changing Community Values for more
detail.
Figure 2-6. Login Screen with Community Options Visible
• If using the system for the first time, enter netman (default) in the
read only and read-write fields.
• If community values have previously been defined, enter them in
the readonly or read-write communities.
2-10 Starting the WinLink1000 Manager Software 9/18/2006 2:26:00 PM