User's Manual

Chapter 2 Installation and Setup WinLink1000 Installation and Operation Manual
3. Click Next.
If TDM services were selected, then the TDM parameters dialog
box appears, (see
Figure 2-16 ).
4. The optimum transmission rate for the selected services is
evaluated. Table shows the rates used by WinLink1000.
If Ethernet only was selected, then the Finish screen appears
(see
Figure 2-17 ) showing a summary of the link configuration,
the alignment is complete.
Table 2-1. Rates per Bandwidth
Modulation/FEC 5 MHz 10 MHz 20 MHz
BPSK / ¾ 2.25 Mbps 4.5 Mbps 9 Mbps
QPSK / ½ 3 Mbps 6 Mbps 12 Mbps
QPSK / ¾ 4.5 Mbps 9 Mbps 18 Mbps
16QAM / ½ 6 Mbps 12 Mbps 24 Mbps
16QAM / ¾ 9 Mbps 18 Mbps 36 Mbps
64QAM /
2
/
3
12 Mbps 24 Mbps 48 Mbps
64QAM / ¾ 13.5 Mbps 27 Mbps
Setting the Clock Configuration
If TDM services are selected then the TDM parameters dialog box
appears.
The TDM Parameters dialog box contains five working modes; select
the appropriate clock mode according to your application. Choosing
one of these modes sets the TDM clock behavior on both sides of the
link. The user equipment must be configured as described
Table 2-2 .
Table 2-2. TDM Clock Modes
Unit clock mode User equipment side
Local Unit Remote
Unit
HQ side Branch side
1 Transparent Transparent Internal/Recov
er
Internal/Recov
er
2-22 Installing the Link 9/18/2006 2:26:00 PM