User's Manual

WinLink1000 Installation and Operation Manual Chapter 4 Configuration
3. If you are not satisfied with the channel that is selected
automatically, click Reselect Channel.
A new channel will be selected from one of the Available
Channels that have been defined.
Note
The reselection process may take a few minutes.
4. Click Next.
The maximum rate is selected according to the link conditions
The quality bar shows the adjustment until the system finds the
best quality link.
6. Click Next.
The Service Parameters dialog box appears.
4.3 Configuring Service Parameters
In the Service Parameters dialog box configure E1/T1,
(x1 or x2 for IDU-E, or x4 for IDU-C) and Ethernet parameters.
Æ
To configure E1/T1 and Ethernet services:
1. In the Service dialog box, select one of the following:
 Ethernet plus a number of E1/T1 channels (see
Figure 4-6 ).
If TDM services are selected, then the Evaluate icon shows on
the screen whilst the maximum rate is evaluated
.
When evaluation is complete the icon changes and the following
message is shown:
Service has been evaluated, click Next to continue
 Ethernet data only (see
Figure 4-7 ).
If Ethernet only was selected, then the Finish screen appears
(see
Figure 4-12 ) showing a summary of the link configuration,
the alignment is complete.
2. Click Next.
The TDM parameters dialog box
Figure 4-11 or the Finish
screen appears depending on which services were selected.
Configuring Service Parameters 4-9