User's Manual Part 1

Installation Chapter 5

RADWIN 2000 User Manual Release 2.5.40 5-13

Figure 5-10: Antenna configuration dialog

2. Choose the antenna type and required transmission (Tx) power for the first site and

click OK. You will receive the following warning:

Figure 5-11: Antenna type change warning

3. Repeat the process for the second site.

4. At the same time you can set the Antenna Gain and Cable Loss.

The Tx Power (per radio) indicates the power of each radio inside the ODU and is

used for Link Budget Calculations. The Tx Power (System) shows the total transmis-

sion power of the ODU and is used to calculate the EIRP according to regulations.

If you choose to set the Antenna Gain and Cable Loss, you will receive the following

warning message:

Note

To see the relationship between Tx Power (radio) and Tx Power (system),

note that so that if you double the power in

milliWatts (for two radios) then dBm will increase by .

dBm 10 milliWatt

log=

10 2 3

log