User's Manual

ManualsBrandsRadwin ManualsElectronicsOutdoor radio unit operating in 5.8GHz band

MIB Parameters Appendix F

RADWIN 1000/2000 User Manual Version 2.12 F-4

MIB Parameters

The following section describes all of the MIB parameters. The MIB parame-

ters follow the following naming convention:

For each of the configuration and control parameters (parameters with

read-write access), the “Description” column describes when the new value

is effective. It is recommended that you perform the appropriate action to

make the values affective immediately after any change. Where a change is

required on both sides of the link, it is recommended that you change both

sides of the link first and then perform the action.

Supported Variables from the RFC 1213 MIB

Table F-1: Supported RFC 1213 Variables (Sheet 1 of 2)

Name OID Type

Access

Description

ifIndex

.1.3.6.1.2.1.2.2.1.1.x

Integer RO A unique value for each interface.Its value ranges

between 1 and the value of ifNumber.The value for

each interface must remain constant at least from

one re-initialization of the entity's network

management system to the next re-initialization.

ifDescr .1.3.6.1.2.1.2.2.1.2 DisplayString RO A textual string containing information about the

interface.This string should include the name of

the manufacturer, the product name and the

version of the hardware interface.

ifType .1.3.6.1.2.1.2.2.1.3 Integer RO The type of interface, distinguished according to

the physical/link protocol(s) immediately `below'

the network layer in the protocol stack.

ifSpeed .1.3.6.1.2.1.2.2.1.5 Gauge RO An estimate of the interface's current bandwidth in

bits per second.For interfaces which do not vary in

bandwidth or for those where no accurate

estimation can be made, this object should ontain

the nominal bandwidth.

ifPhysAddress .1.3.6.1.2.1.2.2.1.6 Phys-Address RO The interface's address at the protocol layer

immediately `below' the network layer in the

protocol stack. For interfaces which do not have

such an address (e.g., a serial line), this object

should contain an octet string of zero length.

ifAdminStatus .1.3.6.1.2.1.2.2.1.7 Integer RW The desired state of the interface. The testing(3)

state indicates that no operational packets can be

passed.

ifOperStatus .1.3.6.1.2.1.2.2.1.8 Integer RO The current operational state of the interface. The

testing(3) state indicates that no operational

packets can be passed.

ifInOctets .1.3.6.1.2.1.2.2.1.10.x Counter RO The total number of octets received on the

interface, including framing characters.

ifInUcastPkts .1.3.6.1.2.1.2.2.1.11.x Counter RO The number of subnetwork-unicast packets

delivered to a higher-layer protocol.

ifInNUcastPkts .1.3.6.1.2.1.2.2.1.12.x Counter RO The number of non-unicast (i.e., subnetwork-

broadcast or subnetwork-multicast) packets

delivered to a higher-layer protocol.