User manual

NMS-4000
Network Management System
P/N 2349-72712-01 Page 2-23
Figure 2-20: System Dialog – System Configuration Tab
Table 2-14: System Dialog Parameters – System
Configuration Tab
PARAMETER DESCRIPTION
IP Address Changes the IP Address of the computer where the
NMS-4000 is running.
Base Port Changes the port number of the NMS-4000. The
port number can be any number but should be
unique throughout the rest of the NMS-4000 in the
master NMS.
Num. Of Port This parameter value should be 1.
Notification Port The Notification Port changes automatically and is
always greater by one from the Base Port. Changes
take effect only after the [OK] or [Apply] buttons
have been pressed.
Community Changes the SNMP community. The NMS-4000
should have the community name: “central”
The community name is case sensitive.
Notif. Type This parameter default value is “Trap” and should
not be changed.
Retransmit Policy –
Timeout (sec)
This parameter value is 10 by default and should not
be changed.
Retransmit Policy –
Retries
This parameter value is 3 by default and should not
be changed.