User manual

User Manual
Chapter 2. Installation
Page 2-30 P/N 2349-72712-01
Table 2-17: Supervisor Configuration Parameters
PARAMETER DESCRIPTION
Notif. Type This parameter default value is “Trap” and should
not be changed.
Retransmit Policy –
Timeout (sec)
This parameter default value is 10 by default and
should not be changed.
Retransmit Policy –
Retries
This parameter default value is 3 by default and
should not be changed.
2.4.5. Site Manager Configuration
The Site Manager Configuration dialog, shown on Figure 2-26, is used to configure the
computer, which the Site Manager is installed upon.
The Site Manager Configuration dialog can be opened from the menu bar:
ConfigurationàSite Manager
Before configuring the site manager, a site name needs to be selected in the Site tab. All
sites needs to be configured.
Table 2-18 explains the Site Manager Configuration dialog parameters.
Figure 2-26: Site Manager Configuration Dialog