User's Manual

For Internal Use Only
SET_ROUTEINTER
VAL Use On:
RTR
RMII 0x42 Type(1)
Interval(
1)
0x43 None Type(1)
Bit7~bit2: reverse,
Bit1: enable route discovery
immediately if set,
Bit0: set route discovery
interval with the value of
Interval(1).
Interval(1)
Routing interval, range is
from 10 to 240, unit is second.
If RTR/Router lost connection
with its next hop, it should route
discovery periodically as per the
value of Interval(1).
CHG_PAN_ID
Use on:
GTW
RTR
STD
Both 0x44 PanID:(
2)
XXXX
0x45 None Change GTW Pan ID into XXXX.
From 0x0001 to 0x03E7(1-999)
Reset automatically.
STD_ENABLE
Use on:
GTW
RTR
STD
Both 0x46 None 0x47 None Put a node into STD. Interrupt
enable and active low.
Baud rate change to 19200 8N1
Reset automatically.
SOFT_RESET
Use on:
GTW
RTR
STD
Both 0x48 None 0x49 None Perform soft reset.
Reset automatically.
FACTORY_RST
Use on:
GTW
RTR
STD
Both 0x4A None 0x4B None Restore the RCM to factory
defaults.
PanId: 0x03E7, Device Type
:
STD.
For RM2400, channel is 0x0f and
txpower is -6dBm and 17dBm
through power amplifier.
For RM900, TBD
Debug print is disable.
STD receiver is disable.
GTW or RTR permit joining is
enable.
Reset automatically.
SET_RECEIVER
Use on:
STD
RMII 0xA0 00 -
Disable
01 -
Enable
0xA1 None Enable or disable STD’s receiver.
STD should receive data packet
from parent if enable receiver;
STD should use poll to request
data packet from parent if disable
receiver.
Reset automatically.