User's Manual

For Internal Use Only
GET_RECEIVER
Use on:
STD
RAEMeshII 0xA2 None 0xA3 Status(1) Return STD receiver’s status,
00 – Disable
01 - Enable
SET_REGION
Use on:
GTW
RTR
STD
RAEMeshII 0xA4 Region(
1)
0xA5 None Region(1)
BAND_868_EU = 0x01,
BAND_915_NA = 0x04,
BAND_2400_ISM = 0x08,
For RM2400, this command is
useless because RM2400 always
work on BAND_2400_ISM.
For RM900, default channel is
0x00 if set region to
BAND_868_EU; default channel
is 0x06 if set region to
BAND_915_NA.
Reset automatically.
GET_REGION
Use on:
GTW
RTR
STD
RAEMeshII 0xA6 None 0xA7 Region(1) Get modem setting of region.
SET_UID
Use on:
GTW
RTR
STD
RAEMeshII 0x4E UID(8) 0x4F None Set radio’s UID(MAC address).
Note:
The last two bytes must not set
to 0x0000, 0xFFF0-0xFFFF
Reset automatically.
JION_FORM_NET
WORK
Use on:
GTW
RTR
STD
Both 0x50 None 0x51 None GTW: Form a network using
customized PANID to allow the
other nodes to join.
RTR/STD: Search the network
using customized PANID and try
to join the network.
GET_ROUTEINTE
RVAL
Use on:
RTR
RAEMeshII 0x52 None 0x53 Interval(1) Return the routing interval.
GET_NODE_INFO
Use on:
GTW
RTR
STD
Both 0x60 None 0x61 UID(8)
Channel(1)
Power(1)
PAN ID(2)
Get the node information: UID,
Channel, Txpower level,, PAN ID,
GET_APPNODE_I
NFO
Use on:
GTW
RTR
STD
Both 0x6C None 0x6D UID(8)
Channel(1)
Power(1)
PAN ID(2)
Get the application information:
UID, Channel, Power, PAN ID. If
the network is not connected, the
GET_NODE_INFO will return
wrong information, and then use
this to get what we set.
GET_PARENT_ID
Use on:
RTR
STD
Both 0x68 None 0x69 Parent radio
ID(8)
0x00 00 00 00 00 00 00 00
means that STD or RTR’s parent
is coordinator/gateway.
0x00 00 00 00 00 00 mm nn
means STD or RTR’s parent is a
RTR which short address is mm