Brochure

8
COMMON SYSTEM DATA
Front panel
Panel cut-out
The actuators featured in the RAFIX 22
FS
+
series are suitable for 22.3 mm pan-
elcut-outsaccordingtoIEC60947-5-1.All
actuators are equipped with a locating
pip. This locating pip ensures the perfect
fit of actuators and contact blocks for
PCB-mounted components and is there-
fore essential for a design built with
these contact blocks.
Grid spacing
The design principle makes it possible
to use a minimum grid spacing of
30 mm x 30 mm. In such an arrange-
ment, actuators with square collars can
be aligned directly without any gaps.
When designing the grid spacing, it is
recommendedtoconsideranyexternal
legendingrequired(for example, using
labels strips inserted into the front
panel).
Assembly of the front actuators
Single-handed assembly method
Forassembly, insert the actuatorinto the mounting hole fromthe front side.It is
clampedinthepanelcutout.Subsequentlyyoucanscrewontheactuatorfromthe
rear using the ring nut. You can perform these steps one after the other with one
hand!Evenbetter:youcanstartbyinsertingallactuatorsfromthefrontsiderstand
subsequently fasten the threaded rings from the rear in one go. We recommend us-
ingtheRAFIXxingspannertoensurepropertightening.
FAST & SLIM
RAFIX 22 FS
+