Operating instructions

17
RailKing 4-Car Subway Set Operating Manual
RAILKING
on page 14). Once in Feature 45, press the whistle button and wait for the
module to sound a bell ding(s). Continue pressing the whistle button until
the module plays back one ding for option 1 - Squeaking brakes are
activated by the bell button with TAS operation. Press the whistle button
again until the module plays back two dings for option 2 - squeaking brakes
are activated for full-time operation, or press the whistle button again until
the module plays back three dings for option 3 -Squeaking brakes off. Once
you have decided on the desired setting, simply turn the throttle off and then
on again to “Lock-In” the new setting. To reset the computer to its original
factory default setting (option 2 - squeaking brakes are activated for full-
time operation), repeat the above procedure but keep pushing the whistle
button until the module only responds with two bell dings.
PROGRAMMING FOR HORN IN NEUTRAL
OPERATION
If you are operating your car with a separate bell button and want to blow
your horn when your car is in neutral, you will need to program
ProtoSounds® to do so as the factory setting only allows the horn to blow in
forward or reverse. To do this, enter RESET and go to Feature 25. (See the
section Using RESET To Program ProtoSounds® on page 14.) Once in
Feature 25, press the
transformer whistle button
and wait for ProtoSounds® to
sound a bell ding(s).
Continue pressing the whistle
button until ProtoSounds®
sounds two bell dings
(signifying that
ProtoSounds® has been
programmed to sound the horn in neutral). Turn the throttle off and then on
again to “Lock-In" your selection. Now, whenever you are in neutral, you
can blow the horn with the transformer whistle button. To reset
ProtoSounds® to its original factory setting of no horn in neutral, repeat the
above procedure but keep pressing the whistle button in Feature 25 until
ProtoSounds® only dings once instead of twice.
Clank, Clank, Clank,
Clank, Clank, Etc.
In RESET Mode
Move The Throttle
Up & Down From
High Voltage To Low
25 Times
Listen For 5 Clank
And 0 Clink Sounds
Push The Whistle Button
Until You Hear
2 Bell Dings
Interrupt The Throttle
To “Lock-In”
The Horn Setting
H