Operating instructions

19
RailKing 4-Car Subway Set Operating Manual
RAILKING
have failed. To activate the Remote Lockout Control setting, go to RESET
Feature 40 (See the section entitled Using RESET To Program
ProtoSounds® on page 14). Once in Feature 40, press the transformer
whistle button and wait for ProtoSounds® to sound a bell ding. Continue
pressing the whistle button until ProtoSounds® sounds two bell dings
signifying that the Remote Lockout Control has been selected. To lock in
the setting, simply turn the throttle all the way off and then back on again.
To turn the Remote Lockout Control setting back off, go back to Feature 40
and press the whistle button until only one bell ding sounds. To lock in the
setting, simply turn the transformer throttle off and then back on again.
Alternatively, you can go to RESET Feature 18 to reset all ProtoSound®
features back to their original factory defaults including Remote Lockout
Control.
RESETTING ALL PROTOSOUND® OPTIONS TO
FACTORY DEFAULTS
ProtoSounds® is equipped with a RESET feature (Feature 18) that resets
all programmable options back to their original factory settings. This is a
useful feature if you find
your engine not operating the
way you think it should and
don’t want to take the time to
check each RESET feature
one at a time. To reset all the
RESET features back to their
original factory settings,
enter RESET and go to
Feature 18. (See the section entitled Using RESET To Program
ProtoSounds® on page 14). Once in Feature 18, press the transformer
whistle button and wait for ProtoSounds® to sound a garbled bell sound.
Interrupt the throttle again to lock in the setting.
Clank, Clank, Etc.
In RESET Mode
Move The Throttle
Up & Down From
High Voltage To Low
18 Times
Listen For 3 Clank
And 3 Clink Sounds
Push The Whistle Button
Until You Hear
A Warbled Bell Ding
Interrupt The Throttle
To “Lock-In”
The Default Settings
H