Operating instructions

20
RailKing E-8 AA Set Operating Manual
Programming PFA Operation
-
Reset Feature 28-(5 Clanks, 3 Clinks)
Reset Feature 28 allows you
to turn the operation of the
PFA sequence on or off.
When OFF, the PFA will
not activate. To use, cycle
to Reset 28 and press the
Horn/Whistle button. The
engine will play a series of
bells. This indicates the
current setting. Each time
the Horn/Whistle button is pressed, Proto-Sound® will cycle to the next
available setting and provide the appropriate bell indicator. The settings for
Reset 28 are 1 Bell = ON, 2 Bells = OFF. When the desired setting is
reached, lock the changes by interrupting the throttle and cycling the engine
into forward.
Activating Remote Lock-Out Control - Reset Feature 40-(8
Clanks, 0 Clinks)
Reset Feature 40 allows you to enable the Reverse Unit Lockout feature of
Proto-Sound®. When enabled, you are able to lock the engine to run in
only one of the directional states (Forward, Neutral or Reverse) whenever
power is applied. The most common use for locking out an engine is in the
use of power blocks on a layout. To use, cycle to Reset 40 and press the
Whistle button. The engine will play a series of bells. This indicates the
current setting. Each time the Whistle button is pressed, Proto-Sound® will
cycle to the next available
setting and provide the
appropriate bell indicator.
The settings for Reset 40
are 1 Bell = OFF, 2 Bells =
ON. When the desired
setting is reached, lock the
changes by interrupting the
throttle and cycling the
engine into forward.
In RESET Mode
Move The Throttle
Up & Down From
High Voltage To Low
40 Times
Listen For 8 Clank
And 0 Clink Sounds
Push The Whistle Button
Until You Hear
2 Bell Dings
Interrupt The Throttle
To “Lock-In”
The Lock-Out Setting
H
In RESET Mode
Move The Throttle
Up & Down From
High Voltage To Low
28 Times
Listen For 5 Clank
And 3 Clink Sounds
Push The Whistle Button
Until You Hear
2 Bell Dings
Interrupt The Throttle
To “Lock-In”
The FYS Setting
H