User Manual

SETTING THE WATERING PATTERN

Rain Bird's AG-5/Maxi-Paw sprinkler may be set to wa-

ter a full or a part circle with a few simple adjustments.

After installation, lift the lid and locate the two pattern

adjusters, or trip collars, and the trip lever.To water full

circle: flip the trip lever up, allowing the head to rotate in

a complete circle (Fig. #8).

To water a part circle: flip the trip lever down, then

slowly move the two pattern adjusters (Fig. #9). The

sprinkler will water the angle you set with the pattern

adjusters (on the opposite side of the trip lever).

NOTE: You will need to fine-tune the arc with the pattern adjusters while the sprinkler is operating.

MAINTENANCE TIPS

Do not use oil, grease, or pipe dope on the sprinkler; it

is water lubricated. If the AG-5/Maxi-Paw sprinkler

fails to operate, check the nozzle for obstructions, verify

that your irrigation timer works properly, and that the

valve(s) open correctly to provide water to the sprinkler.

In cold climates, it is recommended that you purge your

irrigation system with an air compressor when you shut

the system off for the winter; this will blow out any wa-

ter remaining in the sprinklers that might damage them

upon freezing. Refer to Rain Bird's Winterization Guide

for the correct procedure-call us for a free copy. Please

call our Expert Advice hotline if you have questions or require assistance installing your AG-5/Maxi-

Call 1-800-RAIN-BIRD (1-800-724-6247)

We’re Here to Help!

Rain Bird National Sales Corporation

Rain Bird Sales, Inc. Customer Support Center

6640 S. Bonney Ave.Tucson, AZ 85706

1-800-RAIN-BIRD (520) 434-6289 FAX

®Registered Trademark of Rain Bird Sprinkler Mfg. Corp.

Printed in U.S.A.

P/N 141267

BBIRDIRD®RRAINAIN