Full Product Manual

2
Installation
Tools and Supplies Needed
• Phillips screwdriver
• Wire stripper
• Hammer
• Valve wire: direct burial, color coded multi-
strand (not included)
• 18 gauge for runs less than 800 feet.
• 14 gauge for runs greater than 800 feet.
• Watertight splice connectors (not included)
Before Removing Old Timer
24VAC SENSOR COM 1 2 3 4 5 6
AT&T
100%4:21 PM
AT&T
100%4:21 PM
A. Check WiFi signal
With your phone, check WiFi signal strength of your
timer’s location (2 bars minimum is recommended).
Boost signal if needed by adding a wireless router or
moving the timer and router closer together.
B. Take A Photo of Wiring Details
This photo will be useful reference when installing the
new timer.
Record Current Watering Times
Zone Days Per Week Duration
1 Mo, We, Fr 20 minutes
THEN UNPLUG TRANSFORMER/TURN OFF POWER AND
REMOVE WIRES.
Mount Timer
Mount the Timer in an accessible location
NOTE: Indoor models are for indoor use
only. Outdoor models can be used indoors
or outdoors.
NOTE: For indoor models, choose a location
within 6 feet of an AC power outlet and at
least 15 feet away from major appliances or
air conditioners.
Drive a screw into the wall, leaving an 1/8” gap
between the screw-head and the wall (use the
supplied wall anchors if necessary).
Locate the keyhole slot on back of the unit and
hang it securely on the screw.
Remove the wiring bay cover at the bottom of
the unit and drive a second screw through the
center hole at the bottom of the unit as shown
(use the supplied wall anchors if necessary).
INDOOR MODEL
OUTDOOR MODEL
If hard wiring for AC power,
remove knockout for conduit
CONNECT
120 VAC
1/8IN.
1/8IN.
A
B