Specification

®
Registered Trademark of Rain Bird Corporation
© 2008 Rain Bird Corporation 3/08
D39610A
Rain Bird Corporation
6991 E. Southpoint Road
Tucson, AZ 85706
Phone: [phone]
Fax: [phone]
Rain Bird Technical Services
(800) RAINBIRD (U.S. and Canada)
Rain Bird Corporation
970 West Sierra Madre Avenue
Azusa, CA 91702
Phone: [phone]
Fax: [phone]
Specication Hotline
800-458-3005 (U.S. and Canada)
Rain Bird International, Inc.
P.O.
Box 37
Glendora, CA 91740-0037
Phone: [phone]
Fax: [phone]
www.rainbird.com
SPX-100 and SPX-FLEX-100
Swing Pipe Tubing
constructed of linear low density polyethylene
material. The tubing shall have a wall thick-
ness of 0.098” both for the SPX and SPX-FLEX
models. It shall have a nominal inside diameter
of 0.487” for SPX and SPX-FLEX for use with SB
-
sity of glue or clamps. The model number,
manufacturer’s name and date of manufacture
shall be printed at intervals of between 3’ and 6’
along the length of the tubing. Each 18” (46 cm)
length of tubing shall be capable of pressure
testing at the rate of 80 pounds per square inch
(psi) (5,5 bar ) per second to a minimum burst
pressure of 325 psi (22,4 bar) for SP and 350 psi
(24,1 bar) for SPX and SPX-FLEX. The swing pipe
shall be capable of 8 gallons per minute (gpm)
maximum.
The tubing shall have an operating pressure
rating of 80 psi at 110ºF (5,5 bar at 43ºC).
The swing pipe tubing shall be as manufac-
tured by Rain Bird Corporation, Glendora
California.
SB Series Spiral barb Fittings
-
assembly for 1⁄2” (15/21) and 3⁄4” (20/27) inlet
operating water pressure of 80 psi and 8 gpm.
constructed of Acetal thermoplastic material
and be designed so as to permit twist-in inser-
tion, eliminating the need for glue or clamps.
Rain Bird Corporation, Glendora California.
The Intelligent Use of Water™ -- Visit www.rainbird.com to learn about our eorts
SWING PIPE
SWING PIPE
SBE Fitting
SBE Fitting