Use and Care Manual

RECOMMENDED USES:
Split Face Block Stucco
Smooth Block Cement Plaster
Adobe Block Slump Block
Brick Painted Surfaces
Horizontal Concrete Chalked Surfaces
Vertical Concrete Aggregate Panels
Wood Natural Stone
Wall Board EFIS
Clay Roof Tiles Painted Surfaces
COVERAGE RATES (THEORETICAL):
Substrate Sq Ft/ Gallon
Dense Masonry 100-150
Porous Masonry 60-100
Stucco/EFIS 150-200
Wood 175-200
Painted Surfaces 400
Notes: Use of fluted or scored block or raked joints will increase surface
areas by 20%-30% or more and decrease coverage rates.
Warranty Period: Up to Five Years
CSI Reference: Division 3, 4, 7 & 9
Part Numbers: USA International
1 Gallon CR-1401 CR-1401-CA
5 Gallon CR-1405 CR-1405-CA
SATIN-LOK
™
with MICRO-LOK
™
Technology
“Wet–Look” Gloss Masonry and Wood Sealer
PRODUCT DESCRIPTION
SATIN-LOK is a high solids, water-based, modified silicone acrylic water
repellent and sealer that protects and beautifies vertical and horizontal,
interior and exterior masonry, concrete, and painted surfaces with a
beautiful gloss/”wet look” finish.
Features and Benefits:
 Gloss finish repellent and alkali-resistant sealer for masonry and
concrete
 Protects and beatifies surfaces with a “wet look” finish
 For use on interior and exterior surfaces
 Resists flaking and has excellent adhesion
 Protection not effected by weathering or UV light
 Excellent wear and abrasion resistance
 Virtually maintenance-free
 Breathable – does not trap moisture
 Meets Master Painters institute (MPI) #99 - Sealer, Water-Based,
for Concrete Floors
HOW TO USE
SATIN-LOK is supplied ready to use. DO NOT THIN. Mix thoroughly
prior to use. Avoid application in windy weather. In hot weather, lightly
dampen surfaces with clean fresh water to avoid premature or flash dry-
ing.
Porous Vertical Surfaces
Start first coat application at the top of the wall. Apply flood coat with a
6”-8” rundown and back roll material into surface voids. Apply second
coat when the first coat is dry.
Vertical Concrete Surfaces
Material may be applied as soon as the forms are removed. Surfaces
shall be clean and free of form oils and release agents. Start first coat
application at the top of the wall. Apply saturation coat and back roll
materials. Apply second coat when the first coat is dry.
TECHNICAL DATA:
Solvent ` Water
Active Solids Content Approximately 25.0%
Odor Low Odor
Appearance When Dry Dries to a Gloss Finish
V.O.C. <15 g/L
Flash Point None
Weight Approximately 8.7 lbs./gal.
Surface Dry Time Approx 1 Hr
Recoat Approx 1 Hour
Full Chemical Cure
Application Temp
Material Type
72-96 Hours
40° to 90° F
Modified Silicone Acrylic
 UV protectant