Use and Care Manual

achieved (approximately 4-7 days at 75° F) you can expect the full beading effect. Wait to test water repellency after the
full chemical cure period. To conduct a test, simply drip some water in a few places where you have sealed the surface. If
the drips make the surface darken, this is an indication that it is still absorbing, meaning you need to apply another coat.
(This issue is most common with older surfaces).
Clean-Up: Rainguard Water Sealers uses a water based formula. Simply rinse out equipment with clean water until it
runs clear. Any undesired over-spray on windows or glass can be immediately wiped off with a clean cloth. If the product
has already dried it can be washed off quickly with a clean cloth, warm water, and a mild soap.
Anything we missed? Call us at [phone] or email us: [e-mail]
Rev.
03.06.20