Operation Manual

9
PROGRAMMING
STEP 3. Set Station Run Times. (Continued)
To adjust the Run time in minutes press , and use or . To
set the run time in hours, press and “0” will appear and flash.
To adjust use or . If not required, press and advance to
station 2 by pressing the button.
Continue until all the stations in Program 1 have been set with a
run time, or if a station (or stations) are not required to be active in
this particular program, ensure that the run time is set to “OFF”.
Remember all stations are set at a default run time of 10 minutes
in Program 1.
NOTE: To set a station to “OFF”.
Use when the “RUN TIME” is flashing. This completes the setting
up procedure for automatic watering of Program 1.
Should you need a second program.
Turn
the dial to “Set Start Times” and “Prog 1” will flash. press
and change to program 2 position and follow the same 3 steps to set
an automatic watering program.
1. Set Starts
2. Set Watering Days
3. Set Station Run Times
TIP: Remember to return the dial to the “Auto Run” position after
completing the set up of an automatic program.
This will ensure that the automatic cycles will take place.