Operation Manual

3
INTRODUCTION
This controller has been designed with four separate program starts,
to allow different garden areas to have their own individual watering
requirements.
A start is basically a method of grouping stations (valves) with similar
watering requirements to water on the same days. These stations will
water in sequential order from the lowest number at the start time (or
times) nominated and on the days selected.
THE KEY ELEMENTS WHEN PROGRAMMING YOUR
CONTROLLER ARE:
1. Grouping the stations (valves)
Group together garden areas which have similiar watering
requirements. Examples are: Turf Areas, Flower Beds, Pergola/
Undercover Areas, or Vegetables. These different groups require
individual settings.
2. Planning out your watering program.
Complete your individual watering planner, supplied at the back of
this book.
3. Setting the current time and correct day of the week.
4. Setting an automatic program start.
Use the following 3 steps to program each group.
4.1 Set Start(s).
This sets the time of the day when the watering program will
commence.
4.2 Set Watering Days.
These are the nominated days when the automatic system will be
active.
4.3 Set Station Run Times.
This sets the watering duration required for each station (valve).
PROGRAMMING INSTRUCTIONS